BK1600 Ultra
Scope
This firmware is released by product series, not named after a single model. The following models in the same series share the same firmware set:
Indevolt BK1600 Ultra
The firmware package contains the firmware of the CMS, Pfile, EMS, BMS, MPPT, PCS modules. Each module is updated independently, so refer to the relevant section as needed.
CMS
| Release Date | Version | Update Summary |
|---|---|---|
| 2026/09/16 | V140E.12.104C | 1. Added meter offset configuration 2. Added Shelly smart plug control switch 3. Added support for P1 meter 4. Optimized OpenData HTTP API 5. Optimized communication stability |
| 2026/03/06 | V1408.0C.104A | 1. Added support for Stromleser meter (optical reader) 2. Added support for HomeWizard P1 meter 3. Added support for Shelly Plug Gen1 4. Added meter offset configuration |
| 2026/01/19 | V1407.0B.1049 | 1. Optimized communication logic |
| 2025/12/12 | V1406.0B.1047 | 1. Added support for Solarman smart plug, Shelly Plug S MTR Gen3, Shelly 3EM 2. Optimized system operation |
| 2025/10/23 | V1401.0B.0042 | 1. Optimized OpenData 2. Optimized system operation |
| 2025/07/22 | V130A.09.003A | / |
| 2025/06/24 | V1.3.09_R006.062_M4848_00000034 | / |
| 2024/11/25 | V1.3_R006.002_M4848_00000021 | / |
Pfile
| Release Date | Version | Update Summary |
|---|---|---|
| 2026/08/12 | V06.00.12 | Added full-charge calibration setting |
| 2025/12/29 | V06.00.09 | Added bypass control switch |
| 2025/11/14 | V06.00.08 | Added bypass control switch |
| 2025/09/02 | V06.00.06 | / |
| 2024/11/20 | V06.00.05 | 1. Updated battery data points 2. Optimized scheduling logic |
EMS
| Release Date | Version | Update Summary |
|---|---|---|
| 2026/09/16 | V2.00.11 | 1. Optimized the operating logic for bypass socket with microinverter 2. Optimized the operating mode logic |
| 2026/05/22 | V2.00.09 | 1. Optimized power calculation 2. Optimized PV operating logic when SOC reaches 100% 3. Added an AC charging enable option that is effective only when SOC is below 5% 4. Added an Auto Full Charge switch |
| 2025/11/27 | V2.00.04 | 1. Increased bypass port current limit to 10A |
| 2025/09/29 | V2.00.03 | 1. Optimized parallel operation scenarios 2. Added support for slave unit entering deep standby in wired parallel mode |
| 2025/09/12 | V2.00.02 | 1. SOC rounding adjusted (truncate decimals) 2. Meter refresh interval set to 3 seconds 3. Slave power allocated by limit values 4. Zero power set as discharge 5. Micro-inverter fault ignored 6. Added shutdown logging 7. Parameter upgrade compatibility improved 8. Added new status indicators (e.g., recharge) 9. Enhanced overload protection redundancy 10. Line power includes bypass 11. Critical load only responds to bypass 12. Standby changed to deep sleep 13. Optimized deep standby logic 14. Added scheduled full charge 15. Upgraded Modbus to V2.3 16. Fixed parallel discharge issue |
| 2025/06/26 | V2.00.01 | / |
| 2025/03/07 | V2.00.00 | / |
BMS
| Release Date | Version |
|---|---|
| 2025/03/07 | V1.00.35 |
MPPT
| Release Date | Version |
|---|---|
| 2025/09/29 | V3.17 |
| 2025/03/07 | V3.16 |
PCS
| Release Date | Version | Update Summary |
|---|---|---|
| 2026/09/16 | V2.34 | 1.Optimized operating logic |
| 2026/08/10 | V2.33 | 1.Optimized operating logic |
| 2025/05/22 | V2.31 | 1. Optimized the grid-tied relay operating logic |
| 2025/08/28 | V2.21 | |
| 2025/06/26 | V2.17 | |
| 2025/06/20 | V2.15 | |
| 2025/03/07 | V2.07 |